Console Structure

  • Console access via ssh
  • Console access via usb-serial
  • Shell Commands via WebUI – Command Execution
  • Gateway CLI Commands via WebUI – Command Execution
  • Operating system is Linux based. Therefore Linux expertise is mandatory.

Connect via SSH

Use default SSH clients on any desktop

  • Windows – putty
  • Linux – native ssh

On login prompt

  • Username: root
  • Password: < your custom password >

Connect via USB Serial

  • usb to serial cable
    • One must use usb to serial cable + null modem cable
    • If Laptop does not have a serial port then use two usb to serial cables plus null modem cable per diagram below.
  • Connect to any usb port on SBC appliance
    • All SBC appliances have usb port on rear panel
    • 2U SBC appliances have usb port in front panel as well.
  • Configure Terminal Client on Laptop
    • Windows HyperTerminal
    • Linux – mincomm
  • Serial Settings
    • 115200, N, 8, 1 vt100
  • Press enter a few times until a login prompt appears.
    • Login via: username: root, password:

Bash Shell

Once successfully logged into the system, either via ssh or usb serial, user will be offered a bash prompt.

  • SBC system is based on Linux
  • The initial console after login will be a bash shell

System Commands

System commands are based on Linux operating systems.
Listed here are some most useful debugging commands.

  • tcpdump
    • Provides network capture to a pcap file
    • Can be analyzed using wireshark on Desktop or Laptop.
  • ethtool
    • Provides detail network interface information, like Ethernet link status.
    • Run: ethtool for all the options
    • Eg: ethtool eth0 – show Ethernet status
  • Ifconfig
    • Network interface statistics tool
    • Shows error counters on Ethernet and TDM interfaces.
    • Notice the error and overrun counters on wanpipe w1g1 interfaces.
  • nsc_cli
  • Provides SBC CLI

Refer to the appendix for all System Commands

SBC CLI – nsc_cli

  • First log into the System Console (bash)
  • Once on bash prompt run
    • nsc_cli

Command Description

status Shows SBC Status
show channels List all active calls
log [debug, error, crit] Set log level to debug loglevel critical

¿Necesitas más ayuda?
No dudes en ponerte en contacto con nosotros aquí.

¿Te resultó útil?

No
Has indicado que este tema no te resultó útil...
¿Puedes decirnos por qué? ¡Gracias!
Gracias por darnos tu opinión.